Status Indication - Hirschmann OWL 3G User Manual

3.5.1

Status Indication

There are 3 LED indicators on the front panel and 2 LED indicators on every
port, that provide information about the port status.
Applies to software releases before 01.2.01 (2017-01-06):
Caption Color
Power Green
a
WAN Yellow
DA Red
ETH0 Green
ETH1
ETH0 Yellow
ETH1
SIM1 Yellow
SIM2 Yellow
Table 3: Router Status Indication
a. The WAN status is updated every 10 seconds. The WAN LED displays the current status.
Applies to software releases from 01.2.01 (2017-01-06):
Caption Color
Power Green
a
WAN Yellow
DA Red
ETH0 Green
ETH1
ETH0 Yellow
ETH1
Table 4: Router Status Indication
Installation OWL 3G
Release 3 06/2017
State Description
Blinking Router is ready
On Starting of the router
Fast blinking Updating firmware
1x flash per sec. Signal strength is from -50 dBm to -69 dBm
2x flash per sec. Signal strength is from -70 dBm to -89 dBm or
difference between neighbors cells is exactly 3 dBm
3x flash per sec. Signal strength is from -90 dBm to -113 dBm or
difference between neighbors cells is smaller than 3
dBm
Blinking Communication in progress on radio channel
On Selected 100 Mbit/s
Off Selected 10 Mbit/s
On The network cable is connected
Blinking Data transmission
Off The network cable is not connected
On SIM card 1 is active
On SIM card 2 is active
State Description
On Router is ready
Blinking Starting of the router
Fast blinking Updating firmware
1x flash per sec. Signal strength is from -50 dBm to -69 dBm
2x flash per sec. Signal strength is from -70 dBm to -89 dBm or
difference between neighbors cells is exactly 3 dBm
3x flash per sec. Signal strength is from -90 dBm to -113 dBm or
difference between neighbors cells is smaller than 3
dBm
Blinking Communication in progress on radio channel
On Selected 100 Mbit/s
Off Selected 10 Mbit/s
On The network cable is connected
Blinking Data transmission
Off The network cable is not connected
19