Snmptrap Ipaddr - Hirschmann RS20 Reference Manual

CLI Commands: Base

4.4.54 snmptrap ipaddr

This command assigns an IP address to a specified community name. The
maximum length of name is 32 case-sensitive alphanumeric characters.
Note: IP addresses in the SNMP trap receiver table must be unique. If you
make multiple entries using the same IP address, the first entry is retained
and processed. All duplicate entries are ignored.
Format
snmptrap ipaddr <name> <ipaddr> <ipaddrnew>
Mode
Global Config
ipaddr
Enter the old IP Address.
ipaddrnew
Enter the new IP Address.
CLI L2E
Release 8.0 05/2013
4.4 Management Commands
121