Device Status - Hirschmann MICE MS20-0800 Series User Manual

1.2.1

Device status

These LEDs provide information about conditions which affect the operation
of the whole device.
P – Power (green LED)
Glowing green
Not glowing
P1 – Power 1 (green LED)
Glowing green
Not glowing
P2 – Power 2 (green LED)
Glowing green
Not glowing
RM – Redundancy Manager (green/yellow LED)
Glowing green
Glowing yellow
Not glowing
Flashing green
RUN – BOOT/RUN (green LED)
Glowing green
Flashing green
Not glowing
RL1 – Relay 1, signal contact (red/yellow LED)
Glowing red
Glowing yellow
Not glowing
RL2 – Relay 2, signal contact (red/yellow LED)
Glowing red
Glowing yellow
Not glowing
RUN, 1 – display saving processes of the AutoConfiguration Adapter (ACA)
Flashing alternately
LED's flash synchronously
2× a second
LED's flash synchronously
1× a second
If the manual adjustment is active on the signal contact, then the error display
is independent of the setting of the signal contact.
MS20/MS30 MS20/MS30
Release 10 07/2012
Internal supply voltage present.
Internal supply voltage is too low.
Supply voltage 1 is present.
Supply voltage 1 is less than 18 V.
Supply voltage 2 is present.
Supply voltage 2 is less than 18 V.
RM function activeredundant port disabled.
RM function active, redundant port enabled.
RM function not enabled.
Incorrect configuration of the HIPER-Ring (e.g. the ring is not
connected to the ring port).
System is ready for operation.
System is booting.
System is in reset mode.
Signal contact 1 is open, i.e. it is reporting an error.
Signal contact 1 is open, the "Manual Setting" is active.
Signal contact 1 is closed, i.e. it is not reporting an error.
Signal contact 2 is open, i.e. it is reporting an error.
Signal contact 2 is open, the "Manual Setting" is active.
Signal contact 2 is closed, i.e. it is not reporting an error.
Error during saving process.
Loading configuration from the ACA.
Saving the configuration in the ACA.
31