Users Passwd - Hirschmann RS20 Reference Manual

4.7.8 users passwd

This command is used to change a password. The password should not be
more than eight alphanumeric characters in length. If a user is authorized for
authentication or encryption is enabled, the password must be at least eight
alphanumeric characters in length. The username and password are case-
sensitive. When a password is changed, a prompt will ask for the former
password. If none, press enter.
Note: Make sure, that the passwords of the users differ from each other. If
two or more users try to choose the same password, the CLI will display an
error message.
Default
No Password
Format
users passwd <username> {<password>}
Mode
Global Config
no users passwd
U
This command sets the password of an existing operator to blank. When
a password is changed, a prompt will ask for the operator's former pass-
word. If none, press enter.
Format
no users passwd <username> {<password>}
Mode
Global Config
216
4.7 User Account Management Commands
CLI L2E
Release 8.0 05/2013