Status Indication - Hirschmann OWL LTE User Manual

Router Design
3.7.1

Status Indication

There are 3 LED indicators on the front panel and two LED indicators on
every port, that provide information about the port status.
Caption Color
Power Green
WAN Yellow
DAT Red
USR Yellow
POE Yellow
Green
SIM Yellow
Green
IN0 Green
IN1 Green
OUT Yellow
ETH0 Green
ETH1
ETH0 Yellow
ETH1
Table 3: Router Status Indication
The WAN status is updated every 10 seconds. The WAN LED displays the
current status.
26
State Description
Blinking Router is ready
On Starting of the router
Fast blinking Updating firmware
1x flash per sec. Signal strength is from -50 dBm to -69 dBm
2x flash per sec. Signal strength is from -70 dBm to -89 dBm or
difference between neighbors cells is exactly 3 dBm
3x flash per sec. Signal strength is from -90 dBm to -113 dBm or
difference between neighbors cells is smaller than 3
dBm
Blinking Communication in progress on radio channel
— Function of this LED diode can be selected by user
— —
On The voltage present on the ETH0 or ETH1 port
Off The voltage absent from the ETH0 or ETH1 port
On (Yellow color) SIM card 1 is active
On (Green color) SIM card 2 is active
On Binary input no. 0 is active
On Binary input no. 1 is active
On Binary output is active
On Selected 100 Mbit/s
Off Selected 10 Mbit/s
On The network cable is connected
Blinking Data transmission
Off The network cable is not connected
3.7 Description of the Front Panel
UM Installation OWL_LTE
Release 1.0 09/2015