Quick Starting The Switch - Hirschmann RS20 Reference Manual

Quick Start up

2.1 Quick Starting the Switch

D
Read the device Installation Guide for the connectivity procedure. In-band
connectivity allows access to the software locally or from a remote work-
station. The device must be configured with IP information (IP address,
subnet mask, and default gateway).
D
Turn the Power on.
D
Allow the device to load the software until the login prompt appears. The
device's initial state is called the default mode.
D
When the prompt asks for operator login, execute the following steps:
D
Type the word admin in the login area. Since a number of the Quick
Setup commands require administrator account rights, we recom-
mend logging into an administrator account. Press the enter key.
D
Enter the state on delivery password private.
D
Press the enter key
D
The CLI User EXEC prompt will be displayed.
User EXEC prompt:
(Hirschmann Product) >
D
Use "enable" to switch to the Privileged EXEC mode from User EXEC.
Privileged EXEC prompt:
(Hirschmann Product) #
D
Use "configure" to switch to the Global Config mode from Privileged
EXEC.
Global Config prompt:
(Hirschmann Product) (Config)#
D
Use "exit" to return to the previous mode.
26
2.1 Quick Starting the Switch
Release 8.0 05/2013
CLI L2E