Network Mgmt-Access Modify - Hirschmann RS20 Reference Manual

CLI Commands: Base

4.4.13 network mgmt-access modify

This command is used to configure the restricted management access
feature (RMA).
The command modifies an existing rule with <index> to change IP address,
net mask and allowed services.
Format
network mgmt-access modify <index>
Mode
Global Config
<index>
Index of the entry in the range 1..16.
<ip>
Configure IP address which should have access to management
<mask>
Configure network mask to allow a subnet for management access.
<http>
Configure if HTTP is allowed to have management access.
<snmp>
Configure if SNMP is allowed to have management access.
<telnet>
Configure if TELNET is allowed to have management access.
<ssh>
Configure if SSH is allowed to have management access.
enable
Allow the service to have management access.
disable
Do not allow the service to have management access.
CLI L2E
Release 8.0 05/2013
4.4 Management Commands
{ ip <address> |
mask <netmask> |
http {enable | disable} |
snmp {enable | disable} |
telnet {enable | disable} |
ssh {enable |disable } }
87