Snmp Trap Link-Status All - Hirschmann RS20 Reference Manual

4.6.56 snmp trap link-status all

This command enables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled
(see "snmp-server enable traps linkmode" ).
Format
snmp trap link-status all
Mode
Global Config
no snmp trap link-status all
U
This command disables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled
(see "snmp-server enable traps linkmode").
Format
no snmp trap link-status all
Mode
Global Config
CLI L2E
Release 8.0 05/2013
4.6 Device Configuration Commands
187