Snmp-Server Enable Traps Linkmode - Hirschmann RS20 Reference Manual

CLI Commands: Base

4.4.49 snmp-server enable traps linkmode

This command enables Link Up/Down traps for the entire switch. When en-
abled, link traps are sent only if the Link Trap flag setting associated with the
port is enabled (see 'snmp trap link-status' command).
Default
enabled
Format
snmp-server enable traps linkmode
Mode
Global Config
no snmp-server enable traps linkmode
U
This command disables Link Up/Down traps for the entire switch.
Format
no snmp-server enable traps linkmode
Mode
Global Config
116
4.4 Management Commands
Release 8.0 05/2013
CLI L2E