Snmp Trap Link-Status - Hirschmann RS20 Reference Manual

4.5.23 snmp trap link-status

This command enables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled.
See 'snmp-server enable traps linkmode' command.
Format
snmp trap link-status
Mode
Interface Config
no snmp trap link-status
U
This command disables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is en-
abled. See 'snmp-server enable traps linkmode' command).
Format
no snmp trap link-status
Mode
Interface Config
120
4.5 Device Configuration Commands
CLI L2B
Release 4.0 11/07