Lldp Config Chassis Admin-State; Lldp Config Chassis Notification-Interval - Hirschmann RS20 Reference Manual

4.9.14 lldp config chassis admin-state

Configure the LLDP/IEEE802.1AB functionality on this device. If disabled,
the LLDP protocol will become inactive, but the LLDP MIBs can still be
accessed.
D
off: Disable the LLDP/IEEE802.1AB functionality.
D
on: Enable the LLDP/IEEE802.1AB functionality.
The default setting is on.
Format
lldp config chassis admin-state {off|on}
Mode
Global Config

4.9.15 lldp config chassis notification-interval

Configure the LLDP minimum notification interval (the minimum time after a
notification trap has been sent until a new trap can be sent, unit: seconds,
min.: 5 sec., max.: 3600 sec., default: 5 sec.).
Format
lldp config chassis notification-interval
<notification interval>
Mode
Global Config
Notification interval
Configure the LLDP minimum notification interval (the minimum time
after a notification trap has been sent until a new trap can be sent,
unit: seconds, min.: 5 sec., max.: 3600 sec., default: 5 sec.).
CLI L2E
Release 8.0 05/2013
4.9 LLDP - Link Layer Discovery Protocol
253