Users Snmpv3 Accessmode - Hirschmann RS20 Reference Manual
Command line interface industrial ethernet gigabit switch
Hide thumbs
Also See for RS20:
- Reference manual (572 pages) ,
- User manual (294 pages) ,
- Programming manual (116 pages)
Table of Contents
Advertisement
4.7.9 users snmpv3 accessmode
This command specifies the snmpv3 access privileges for the specified login
user. The valid accessmode values are readonly or readwrite. The
<username> is the login user name for which the specified access mode
applies. The default is readwrite for 'admin' user; readonly for all other
users
Default
admin -- readwrite; other -- readonly
Format
users snmpv3 accessmode <username> <readonly |
readwrite>
Mode
Global Config
no users snmpv3 accessmode
U
This command sets the snmpv3 access privileges for the specified login
user as readwrite for the 'admin' user; readonly for all other users.
The <username> is the login user name for which the specified access
mode will apply.
Format
no users snmpv3 accessmode <username>
Mode
Global Config
CLI L2E
Release 8.0 05/2013
4.7 User Account Management Commands
217
Advertisement
Table of Contents
