System Utilities; Address-Conflict - Hirschmann RS20 Reference Manual

4.8

System Utilities

This section describes system utilities.

4.8.1 address-conflict

This command configures the setting for detection possible address conflicts
of the agent´s IP address with other devices´ IP addresses in the network.
Format
address-conflict
{detection-mode { active-only | disable |
enable | passive-only}|
ongoing-detection { disable | enable } }
Mode
Global Config
detection mode
Configure the device's address conflict detection mode (active-only,
disable, enable or passive-only). Default: enable.
ongoing detection
Disable or enable the ongoing address conflict detection.
Default: enable.
220
4.8 System Utilities
CLI L2E
Release 8.0 05/2013