Classofservice Trust - Hirschmann RS20 Reference Manual
Command line interface industrial ethernet gigabit switch
Hide thumbs
Also See for RS20:
- Reference manual (572 pages) ,
- User manual (294 pages) ,
- Programming manual (116 pages)
Table of Contents
Advertisement
CLI Commands: Base
4.3.3 classofservice trust
This command sets the class of service trust mode of an interface. The mode
can be set to trust one of the Dot1p (802.1p) or IP DSCP packet markings.
Note: In trust ip-dscp mode the switch modifies the vlan priority for out-
going frames according to
– the a fix mapping table
(see Reference Manual „GUI Graphical User Interface" (Web-based
Interface) for further details).
Format
classofservice trust dot1p | ip-dscp
Mode
Global Config
no classofservice trust
U
This command sets the interface mode to untrusted, i.e. the packet prior-
ity marking is ignored and the default port priority is used instead.
Format
no classofservice trust
Modes
Global Config
74
4.3 Class of Service (CoS) Commands
CLI L2E
Release 8.0 05/2013
Advertisement
Table of Contents
