Classofservice Dot1P-Mapping - Hirschmann RS20 Reference Manual

CLI Commands: Base

4.3.1 classofservice dot1p-mapping

This command maps an 802.1p priority to an internal traffic class for a device
when in 'Global Config' mode. The number of available traffic classes may
vary with the platform. Userpriority and trafficclass can both be the range
from 0-7. The command is only available on platforms that support priority to
traffic class mapping on a 'per-port' basis, and the number of available traffic
classes may vary with the platform.
Format
classofservice dot1p-mapping
<userpriority> <trafficclass>
Mode
Global Config or Interface Config
userpriority
Enter the 802.1p priority (0-7).
trafficclass
Enter the traffic class to map the 802.1p priority (0-3).
no classofservice dot1p-mapping
U
This command restores the default mapping of the 802.1p priority to an
internal traffic class.
Format
no classofservice dot1p-mapping
Modes
Global Config or Interface Config
72
4.3 Class of Service (CoS) Commands
CLI L2E
Release 8.0 05/2013