Monitor Session <Session-Id> Source/Destination - Hirschmann RS20 Reference Manual

4.6.13 monitor session <session-id> source/
destination
This command allows you to configure and activate the port mirroring func-
tion of the switch. Port mirroring is when the data traffic of a source port is
copied to a specified destination port. The data traffic at the source port is not
influenced by port mirroring. A management tool connected at the specified
port, e.g., an RMON probe, can thus monitor the data traffic of the source
port.
Note: In active port mirroring, the specified destination port is used solely for
observation purposes.
Default
none
Format
monitor session {source | destination} interface
<slot/port>
Mode
Global Config
session-id
Session number (currently, session number 1 is supported).
no monitor session <session-id> source/destination
U
This command resets the monitor session (port monitoring) source/desti-
nation. The port will be removed from port mirroring
Format
no monitor session <session-id> {source | destina-
tion} interface
Mode
Global Config
session-id
Session number (currently, session number 1 is supported).
CLI L2E
Release 8.0 05/2013
4.6 Device Configuration Commands
149