Monitor Session - Hirschmann RS20 Reference Manual

4.6.11 monitor session

This command configures a probe port and a monitored port for monitor ses-
sion (port monitoring). The first slot/port is the source monitored port and the
second slot/port is the destination probe port. If this command is executed
while port monitoring is enabled, it will have the effect of changing the probe
and monitored port values.
Format
monitor session
[ mode |
source interface <slot/port>
destination interface <slot/port> ]
Mode
Global Config
session-id
Session number (currently, session number 1 is supported).
mode
Enable/Disable port mirroring session.
Note: does not affect the source or destination interfaces.
source interface <slot/port>
Configure the source interface (in slot/port notation).
direction
Configure the direction of the interface.´
rx
Configure the direction of the interface as rx (receive).
tx
Configure the direction of the interface as tx (transmit).
rx/tx
Configure the direction of the interface as rx/tx (receive and transmit).
destination interface <slot/port>
Configure the probe interface (in slot/port notation).
146
4.6 Device Configuration Commands
[direction { rx | tx | tx/rx } ] |
CLI L2E
Release 8.0 05/2013