Device Status - Hirschmann MICE MS20-1600 Series User Manual

1.4.1

Device status

These LEDs provide information about conditions which affect the operation
of the whole device.
P – Power (green LED)
Glowing green
Not glowing
P1 – Power 1 (green LED)
Glowing green
Not glowing
P2 – Power 2 (green LED)
Glowing green
Not glowing
RM – Redundancy Manager (green/yellow LED)
Glowing green
Glowing yellow
Not glowing
Flashing green
RUN – BOOT/RUN (green LED)
Glowing green
Flashing green
Not glowing
RL1 – Relay 1, signal contact (red/yellow LED)
Glowing red
Glowing yellow
Not glowing
RL2 – Relay 2, signal contact (red/yellow LED)
Glowing red
Glowing yellow
Not glowing
RUN, 1 – display saving processes of the AutoConfiguration Adapter (ACA)
Flashing alternately
LED's flash synchronously
2× a second
LED's flash synchronously
1× a second
If the manual adjustment is active on the signal contact, then the error display
is independent of the setting of the signal contact.
28
Internal supply voltage present.
Internal supply voltage is too low.
Supply voltage 1 is present.
Supply voltage 1 is less than 18 V.
Supply voltage 2 is present.
Supply voltage 2 is less than 18 V.
RM function activeredundant port disabled.
RM function active, redundant port enabled.
RM function not enabled.
Incorrect configuration of the HIPER-Ring (e.g. the ring is not
connected to the ring port).
System is ready for operation.
System is booting.
System is in reset mode.
Signal contact 1 is open, i.e. it is reporting an error.
Signal contact 1 is open, the "Manual Setting" is active.
Signal contact 1 is closed, i.e. it is not reporting an error.
Signal contact 2 is open, i.e. it is reporting an error.
Signal contact 2 is open, the "Manual Setting" is active.
Signal contact 2 is closed, i.e. it is not reporting an error.
Error during saving process.
Loading configuration from the ACA.
Saving the configuration in the ACA.
Installation MS20/MS30
Release 11 07/2013