Table of Contents
Advertisement
4-24
2. Touch the Remote A, Remote B or Remote C tab to open the tab. The
tab label indicates the current remote modem address setting. The
Remote A tab is shown in Figure 4-31 on page 4-23.
3. Touch the Remote Address
setting.
The remote address keypad opens
as shown in Figure 4-32.
4. Enter the remote modem address,
two characters maximum, and
then touch OK. To backspace and
delete a character, touch the
Delete pad.
The keypad closes and the modem
address is displayed as the
Remote Address setting.
5. If desired, select the remote modem address for one or both of the
remaining tabs.
Configuring the Baud Rate and Transmit Power
Level of a Remote Modem
To configure the baud rate and transmit power level of a remote modem:
1. Touch the tab in the Modem Config screen for the modem to be
configured.
2. On the tab, touch the Remote Acoustic Baud Rate setting and select the
baud rate for the remote modem.
3. Touch Set Remote for the remote acoustic baud rate setting.
An information window temporarily opens indicating that the remote
modem settings are being updated. When complete, the update is
confirmed, and then the Set Remote button becomes unavailable for that
remote acoustic baud rate selection only. If the update is not confirmed,
a no response indication is displayed in the window.
4. Touch the Remote Transmit Power Level setting and select the
attenuation level for the remote modem.
User's Manual
TELEDYNE BENTHOS
Figure 4-32 Remote Address
Keypad
P/N M-270-10, Rev. B
Advertisement
Table of Contents
