Image – Write - Ricoh A250 Service Manual

Hide thumbs Also See for A250:

Table of Contents

3.3.3 [IMAGE] – [WRITE]

Source file name that is currently active in the application.

Card slot number that has a flash memory card currently installed.

If this is checked, the application erases the whole card before writing

before write

data from the source file.

The default setting is checked (= erase).

Start Address

A "0 (zero)" appears at default.

Change this setting if necessary.

Hexadecimal length of the source file appears at default.

Do not change the setting.

Base of Address/

Do not change the settings.

The default setting is "Hex".

After writing the data to a flash memory card, an 8-bit checksum

you can compare it with the checksum

of the source file.

pops up, so that

Chapters

Table of Contents