Ricoh A250 Service Manual page 486

BIT SWITCHES
System Switch 1E
No FUNCTION
0 Communication after the
Journal data storage area has
become full
0: Possible
1: Impossible
1 Action when the SAF memory
has become full during
scanning
0: The current page is erased.
1: The entire file is erased.
2 RTI/CSI display priority
0: RTI 1: CSI
3 File No. printing
0: Enabled
1: Disabled
4 Action when authorized
reception is enabled but
authorized RTIs/CSIs are not
yet programmed:
0: All fax reception is disabled
1: Faxes can be received if
the sender has an RTI or CSI
5 Address display priority in the
AI redial mode.
0: RTI/CSI
1: Telephone number
6
Not used
A250
COMMENTS
This setting is effective only when Automatic
Journal printout is enabled.
0: If the buffer memory of the communication
records for the Journal is full, fax communications
are still possible. But the machine will overwrite
the oldest communication records.
1: If the buffer memory of the communication
records for the Journal has become full, fax
communications will become impossible, to
prevent overwriting the communication records
before the machine prints them out.
Cross Reference
Y
Automatic Journal output - User switch 03 bit 7
Y
Number of communication records for the
Journal:
100 records (standard)
900 records (with the EXMEM board installed)
0: If the SAF memory becomes full during
scanning, the successfully scanned pages are
transmitted.
1: If the SAF memory becomes full during
scanning, the file is erased and no pages are
transmitted.
Not applicable to parallel memory transmission
This bit determines which identifier, RTI or CSI, is
displayed on the LCD while the machine is
communicating in G3 non-standard mode.
1: File numbers are not printed on any reports.
If authorized reception is enabled but the user has
stored no acceptable sender RTIs or CSIs, the
machine will not be able to receive any fax
messages.
If the customer wishes to set up the authorized
reception feature in this way, change this bit to "1"
before enabling Authorized Reception. Messages
from senders that include an RTI or CSI will be
received.
Otherwise, keep this bit at "0 (default setting)".
0: When the machine has both RTI/CSI and the
telephone number information, the machine
displays RTI/CSI.
1: The machine always displays the telephone
number.
Do not change the settings
4-24 SM