Ricoh A250 Service Manual page 196

SERVICE PROGRAM MODE
Class Class
1 and 2 3
5-808*
5-809*
⇒
5-810
5-811
1
5-812*
⇒
2
5-816*
1
5-817
2
5-821
A250
Mode No.
Display Language
mm/inch Selection
SC Code Reset
Serial Number Input
Service Telephone
Number (Telephone)
Service Telephone
Number (Facsimile)
CSS Function
CE Start/Finish Call
(CE Start Call)
CE Start/Finish Call
(CE Finish Call)
CSS-PI Device Code
Function
Selects the display language.
See "Display language" for details.
Selects whether mm or inches are
used in the display.
Resets the service call condition of
Level "A" (see "Troubleshooting -
Service Call Conditions"). After
performing this SP mode, turn the
machine main switch off and on.
See "Troubleshooting - Service Call
Conditions" for how to use this
mode. If the reset was successful,
the beeper will sound 5 times. If it
failed, the beeper will sound only
twice.
Use to input the machine serial
number. (Normally done at the
factory.)
This serial number will be printed on
the system parameter list. See the
"Serial Number Input" section for
details.
Use this to input the telephone
number of the service representative
(this is displayed when a service call
condition occurs).
Press the ! key if you need to input
a pause (–). Press the "
(Clear/Stop) key to delete the
telephone number.
Use this to input the fax number of
the service representative
(Displayed in the SMC and counter
printouts).
Press the ! key if you need to input
a pause (–). Press the "
(Clear/Stop) key to delete the
telephone number.
This SP is for Japan only. Do not
change the value.
This SP is for Japan only. Do not
change the value.
This SP is for Japan only. Do not
change the value.
4-28
Rev. 12/99
Settings
0: mm
(Europe/Asia
model)
1: inch
(American
model)
0: No
1: Yes
SM