Ricoh A250 Service Manual page 558

ERROR CODES
Code Meaning
0-06 The other terminal did not
reply to DCS
0-07 No post-message
response from the other
end after a page was sent
0-08 The other end sent RTN or
PIN after receiving a page,
because there were too
many errors
0-14 Non-standard post
message response code
received
A250
Suggested Cause/Action
• Check the line connection.
• Check the FCU - NCU connectors.
• Try adjusting the tx level and/or cable equalizer
settings.
• Replace the NCU or FCU.
• The other end may be defective or
incompatible; try sending to another machine.
• Check for line problems.
Cross reference
• See error code 0-04.
• Check the line connection.
• Check the FCU - NCU connectors.
• Replace the NCU or FCU.
• The other end may have jammed or run out of
paper.
• The other end user may have disconnected the
call.
• Check for a bad line.
• The other end may be defective; try sending to
another machine.
• Check the line connection.
• Check the FCU - NCU connectors.
• Replace the NCU or FCU.
• The other end may have jammed, or run out of
paper or memory space.
• Try adjusting the tx level and/or cable equalizer
settings.
• The other end may have a defective
modem/NCU/FCU; try sending to another
machine.
• Check for line problems and noise.
Cross reference
• Tx level - NCU Parameter 01 (PSTN)
• Cable equalizer - G3 Switch 07 (PSTN)
• Dedicated Tx parameters - Section 4
• Check the FCU - NCU connectors.
• Incompatible or defective remote terminal; try
sending to another machine.
• Noisy line: resend.
• Try adjusting the tx level and/or cable equalizer
settings.
• Replace the NCU or FCU.
Cross reference
• See error code 0-08.
7-2 SM