Ricoh A250 Service Manual page 720

Hide thumbs Also See for A250:

Table of Contents

1. The default setting of the Printer Main Magnification

(SP2-998) has been changed to 0.2% from 0.0%.

2. Sometimes SC620 is not cleared when the machine

goes into sleep mode.

3. SC101 is sometimes displayed when the ADF stamp

is activated.

4. If the remaining amount of paper shifts to the next

lowest value while the counter report is being

printed, the print job is canceled.

1. The machine cannot determine the 8k and 16k when

auto-enlarge / auto-reduce is performed.

2. When the machine goes into low power mode while

warming up, the temperature of the fusing unit does

not drop as it should.

3. When clearing the NV-RAM memory, the setting for

the polygon motor idling time (SP2-915) is 15 sec

(1), although it should be 25 sec (2).

4. The firmware was changed so that a SC620 is

displayed when an ADF from another machine is

1. The default setting for the maintenance LED (SP5-

908) has been changed to 1 (Yes) from 0 (No).

2. When the value of the total counter is over 9999 or a

negative value, the SC history is displayed

incorrectly (out of order).

3. If the machine receives a fax during a print or copy

job (with rotate-sort), the polygon motor does not

stop after the job is completed.

4. The machine occasionally required the Interrupt key

to be depressed more then once to produce a

Initial Production

Rev. 01/2000

Chapters

Table of Contents