ROM HISTORY
Description of Modification
-Upgrade the NIB firmware to version 4.0.6 or later
and the PS3 firmware to version 1.2.4 or later.
-Set NIC to bi-directional-mode (refer to NIC
manual).
-Do not set Bit SW3, bit 2 to 1 (as explained above,
these two SW should not be simultaneously
enabled).
* To deactivate the DAZEL support function, set Bit
SW3, bit 4 to 1 (0=Enabled, 1=Disabled).
⇒
•
When printing from a certain DOS application,
the right part of the internal print pattern is
missing.
•
When using a certain DOS (CAD) application,
the paper size and/or paper feed direction are
not sent to the controller, and the machine
uses the defaults
•
When printing out with a certain macro, the
frame and lower area of the image are
missing.
•
When using the Dazel system, the job cannot
be reset after the paper feed tray reaches
paper end.
•
After an A4 LEF print job is completed and the
ON Line key is pressed, it takes a relatively
long time to enter OFF Line mode.
•
The controller stalls when the test document
(A4 LEF) for Corel Draw 9 is printed.
A250
Firmware
Level
B3055280 J
B3055280 K
6-8
Rev. 7/2001
Serial
Firmware
Number
Version
Dec. 2000
1.4.8
Production
Feb. 2001
1.4.9
Production
SM