Ricoh A250 Service Manual page 648

ROM HISTORY
Description of Modification
-Upgrade the NIB firmware to version 4.0.6 or later
and the PS3 firmware to version 1.2.4 or later.
-Set NIC to bi-directional-mode (refer to NIC
manual).
-Do not set Bit SW3, bit 2 to 1 (as explained above,
these two SW should not be simultaneously
enabled).
* To deactivate the DAZEL support function, set Bit
SW3, bit 4 to 1 (0=Enabled, 1=Disabled).
•
When printing from a certain DOS application,
the right part of the internal print pattern is
missing.
•
When using a certain DOS (CAD) application,
the paper size and/or paper feed direction are
not sent to the controller, and the machine
uses the defaults
•
When printing out with a certain macro, the
frame and lower area of the image are
missing.
•
When using the Dazel system, the job cannot
be reset after the paper feed tray reaches
paper end.
•
After an A4 LEF print job is completed and the
ON Line key is pressed, it takes a relatively
long time to enter OFF Line mode.
•
The controller stalls when the test document
(A4 LEF) for Corel Draw 9 is printed.
⇒
•
For Dazel: When a stack job has been
cancelled, a mismatch occurs between the
actual number of pages printed out and the
number reported to the server.
•
OCR font does not download into the HDD.
•
With the PS driver, the printer does not print
out jobs when the Separator function has been
selected.
•
Configuration Sheet does not print out.
•
When a job has been sent with the PS driver
but the tray has not been specified (w/manual
selection), the machine does not inform the
Aficio Manager of this error.
•
When using the PS driver for a collated print
job (bypass feed), only the 1st set is printed
out.
•
Buffer size error occurs during data
communication over IEEE1284 ECP.
A250
Firmware
Level
B3055280 J
B3055280 K
B3055280 L
6-8
Rev. 11/2002
Serial Firmware
Number Version
Dec. 2000 1.4.8
Production
Feb. 2001 1.4.9
Production
Sept. 2001 1.5.4
Production
SM