Ricoh A250 Service Manual page 565

Code Meaning
9-40 CRC error during PC fax
communication
9-41 Third failure during PC fax
communication
9-42 DCN received
unexpectedly during PC
fax communication
9-43 Frame received
unexpectedly during PC
fax communication
9-44 Response time over during
PC fax communication
9-45 Frame transmission error
during PC fax
communication
9-61 Memory overflow occurs
during reception
22-00 Original length exceeded
the maximum scan length
22-01 Memory overflow while
receiving
22-02 Tx or rx job stalled due to
line disconnection at the
other end
22-04 The machine cannot store
received data in the SAF
23-00 Data read timeout during
construction
25-00 The machine software
resets itself after a fatal
transmission error occurred
F0-xx V.34 modem error
SM
Suggested Cause/Action
• Check the serial interface and cable
connection between the PC.
• Replace the DIU (PCFE board) or FCU.
Check the SAF.
• Divide the original into a few pages.
• Check the resolution used for scanning. Lower
the scan resolution if possible.
• Add optional page memory.
• Wait for the files in the queue to be sent.
• Delete unnecessary files from memory.
• Transfer the substitute reception files to an
another fax machine, if the machine's printer is
busy or out of order.
• Add an optional SAF memory card or hard
disk.
• The job started normally but did not finish
normally; data may or may not have been
received fully.
• Restart the machine.
• Update the ROM
• Replace the FCU.
• Restart the machine.
• Replace the FCU
• Update the ROM
• Replace the FCU.
• Replace the FCU.
7-9
ERROR CODES
A250