Ricoh A250 Service Manual page 908

ROM HISTORY
B308 POSTSCRIPT OPTION FIRMWARE MODIFICATION HISTORY
DESCRIPTION OF MODIFICATION
⇒
Corrects the following:
•
The print speed slows down during
continuos printing of a 1-page job.
** To activate this correction, it is
necessary to set Bit SW3, bit 2 to 1
(0=Disabled, 1=Enabled) and set Bit
SW3, bit 4 to 1 (DAZEL* support function
disabled). The correction will not be
effective if both of these switches are
enabled.
•
Firmware modified so that the controller
can connect to and be used with the
DAZEL System. However, the
A265/A267 is not yet officially certified by
DAZEL Corp.
When you enable this function, it is
necessary to do the following:
-Upgrade the NIB firmware to version
4.0.6 or later and the PS3 firmware to
version 1.2.4 or later.
-Set NIC to bi-directional-mode (refer to
NIC manual).
-Do not set Bit SW3, bit 2 to 1 (as
explained above, these two SW should
not be simultaneously enabled).
* To deactivate the DAZEL support
function, set Bit SW3, bit 4 to 1
(0=Enabled, 1=Disabled).
FIRMWARE
LEVEL
B3085280 E
November '00
Production
1-2
Rev. 12/2000
SERIAL FIRMWARE
NUMBER VERSION
1.2.4