Installation; Hardware Installation; Utility Software Setup; Printer Manager For Admin - Ricoh A250 Service Manual

Hide thumbs Also See for A250:

Table of Contents

2. INSTALLATION

Refer to the base engine or printer controller installation instructions for how to

install the network interface board.

The machine does not print a NIB status sheet automatically. Print the NIB status

sheet by pressing the push switch (SW1) on the NIB after installation.

One of the following utilities is required to monitor and set up the NIB. The utilities

are on the Drivers and Utilities CD-ROM that comes with the base machine or

Printer Manager for Admin comes with NIB Setup Tool.

1. Install Printer Manager for Admin from the CD-ROM. (Use Custom Setup when

installing the software from the Autorun installation program.)

2. Start the NIB Setup Tool from the menu.

NOTE: Do not use the MAP utility for this type of NIB.

The built-in web server provides an interface to monitor and manage the NIB from

a remote host.

1. Assign an IP address to the NIB.

2. Access "http:// <IP address of the NIB> / from a web browser.

NOTE: 1) Use Printer User Tools at the machine's operation panel to assign an IP

2) Help for the Web Status Monitor is on the Drivers and Utilities CD-ROM.

After you can access the NIB web server, set up the "Help URL"

parameter in the [Network Config.] – [General] page as follows:

<CD-ROM drive letter>:\HELP\WSHELP\EN\index.htm

INSTALLATION

Table of Contents