Ricoh A250 Service Manual page 491

Scanner Switch 0B
No FUNCTION
0 Scan margin setting (top and bottom margin in book scan mode, and top margin in
to ADF mode)
3 The setting can be between 0 and F (H) (in mm).
Default setting: 3 mm
If the scanned image margin is still incorrect after adjustment, the base copier's SP
mode settings may be incorrect. Check and adjust SP modes 4-012-1 and 6-006-
2.
4 Scan margin setting (bottom margin in ADF mode)
to The setting can be between 0 and 7 (H) (in mm).
6 Default setting: 2 mm
If the scanned image margin is still incorrect after adjustment, the base copier's SP
mode settings may be wrong. Check and adjust SP modes 4-012-1 and 6-006-2.
7
Not used
Scanner Switch 0C
No FUNCTION
0 Action when an original jam
has occurred while scanning
the original into memory for
memory tx
0: Continues scanning after
recovery
1: Stops scanning and erases
all scanned pages for that job
1 Setting when an original size
to cannot be recognized
2 Bit 2 1 Setting
0 0 Depending on the
copier's setting

0 1 A5
1 0 A5
1 1 No original
3-5 Not used
6 Scan width used for a
document set in the ADF
when the width is less than
230 mm.
0: A4 (210 mm),
1: LT (216 mm)
7
Not used
SM
COMMENTS
Do not change the settings.
COMMENTS
This bit is only effective when parallel memory tx
is disabled (user parameter 07 - bit 2).
If parallel memory tx is enabled, the machine
always erases the scanned pages when an
original jam occurs. The machine then asks the
user to retry from the first page, even if the
parallel memory tx is not actually used.
0: The machine displays a message asking the
user to put the jammed page back into the original
stack, and continues scanning.
The message is displayed for the time period
specified by scanner switch 0E, bit 2.
1: The machine erases all the scanned pages and
asks the user to retry from the first page.
When both bits are set to "0", the machine
recognizes an original size depending on SP4-
303 copier's service mode.
Do not change the settings.
This bit is set at "1" when the country code is set
to the US.
Do not change the settings.
4-29
BIT SWITCHES
A250