Ricoh A250 Service Manual page 480

BIT SWITCHES
System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
System Switch 09
No FUNCTION
0
Addition of image data from
confidential transmissions on
the transmission result report
0: Disabled 1: Enabled
1 Inclusion of communications
on the Journal when no image
data was exchanged.
0: Disabled 1: Enabled
2
Automatic error report printout
0: Disabled 1: Enabled
3 Printing of the error code on
the error report
0: No 1: Yes
4
Not used
5 Power failure report
0: Disabled 1: Enabled
6
Conditions for printing the
protocol dump list
0: Print for all communications
1: Print only when there is a
communication error
7 Priority given to various types
of remote terminal ID when
printing reports
0: RTI > CSI > Dial label >
Tel. number
1: Dial label > Tel. number >
RTI > CSI
A250
COMMENTS
If this feature is enabled, the top half of the first
page of confidential messages will be printed on
transmission result reports.
0: Communications that reached phase C
(message tx/rx) of the T.30 protocol are listed on
the Journal.
1: Communications that reached phase A (call
setup) of T.30 protocol are listed on the Journal.
This will include telephone calls.
0: Error reports will not be printed.
1: Error reports will be printed automatically after
failed communications.
1: Error codes are printed on the error reports.
Do not change the settings.
1: A power failure report will be automatically
printed after the power is switched on if a fax
message disappeared from the memory when the
power was turned off last.
This switch becomes effective only when system
switch 00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a
protocol dump list only for communications with
errors.
This bit determines which set of priorities the
machine uses when listing remote terminal names
on reports.
In G4 communication, G4_TID (Terminal ID) is
used instead of RTI or CSI. (G4 is for the Europe
model only.)
Dial Label: The name stored, by the user, for the
Quick/Speed Dial number.
4-18 SM