Ricoh A250 Service Manual page 483

System Switch 11
No FUNCTION
4 Type of TTI used for
transmission using the ten-
key pad
0: TTI_1
1: TTI_2
5-6 Not used
7 Use of parallel memory
transmission with G4
transmission
0: Disabled 1: Enabled
G4: Europe model only
System Switch 12
No FUNCTION
0 TTI/CIL printing position in the
to main scan direction
7
CIL: Command Information
Line (Group 4)
G4: Europe model only
System Switch 13 - Not used (do not change the settings)
System Switch 14 - Not used (do not change the settings)
System Switch 15
No FUNCTION
0
Not used
1
Going into the Night mode
automatically
0: Enabled
1: Disabled
2 Protocol dump data backup
0: Disabled
1: Enabled
3-7 Not used
SM
COMMENTS
1: The machine uses TTI_2 when the user dials
the destination using the ten-key pad. It is also
used for polling transmission and manual
transmission using the handset.
Do not change the factory settings.
This determines whether parallel transmission
can be used with a G4 transmission or not.
Note that this bit is only effective if Parallel
Memory transmission is enabled (User Parameter
07 - bit 2).
COMMENTS
TTI/CIL: 08 to 64 (BCD) mm
Input even numbers only.
This setting determines the print start position for
the TTI and CIL from the left edge of the paper. If
the TTI is moved too far to the right, it may
overwrite the file number which is on the top right
of the page. On an A4 page, if the CIL is moved
over by more than 60 mm, it may overwrite the
page number.
COMMENTS
Do not change the settings.
1: The machine will restart from the Energy Saver
mode quickly, because the +5V power supply is
active even in the Energy Saver mode.
1: The machine backs up the protocol dump data
for approximately one hour when the main switch
is turned off, in the same way as image data.
Do not change the settings.
4-21
BIT SWITCHES
A250