Ricoh A250 Service Manual page 427

SCANNING FEATURES
NOTE: 1) Even if Parallel Memory Transmission is enabled, the machine uses
normal memory transmission to send an A4 or 8.5 x 11" sideways
original.
2) If the machine carries out this function while printing, the machine stops
printing until scanning is completed.
3) The machine determines if it will rotate the image after the paper size is
determined.
4) This feature is not performed during parallel memory transmission.
5) In Book mode, the machine determines image rotation for each page
scanned.
In ADF mode, the machine determines image rotation for the first page.
If it is rotated, the machine will check each page. If the first page need
not be rotated, the machine will not check the rest of the pages.
6) When this feature is enabled for A5 or HLT lengthwise, 'APS small
original detection' must be changed. This allows the machine to detect
an A5/HLT size original. With the default setting, the machine does not
detect A5 or HLT lengthwise in book mode.
Cross Reference
• Image rotation before Tx A3 or 11" width original on/off
- Scanner switch 0F, bit 0 (Default setting is enabled)
• Image rotation before Tx A5 or HLT width original on/off
- Scanner switch 0F, bit 2 (Default setting is disabled)
• Image rotation before Tx B5 width original on/off
- User Parameter switch 19, bit 3 (Default setting is disabled)
• APS small size original detection
• Base copier's SP 4-303 (Default setting is "Not detected")
• Scanner switch 0C, bits 1 and 2
(Default setting is "Depends on the setting of the base copier")
A250 2-6 SM