Hps-To-Fpga Mpu Event Interface - Altera cyclone V Technical Reference

29-14

HPS-to-FPGA MPU Event Interface

HPS-to-FPGA MPU Event Interface
The HPS-to-FPGA MPU event interface is connected to an Altera conduit BFM for simulation. The
following table lists the name of each interface, along with API function names for each type of simulation.
You can monitor the interface state changes or set the interface by using the API listed.
Table 29-20: HPS-to-FPGA MPU Event Interface Simulation Model
The usage of conduit
BFM.
Interface Name
h2f_mpu_
events
Related Information
Avalon Verification IP Suite User Guide
Interrupts Interface
The FPGA-to-HPS interrupts interface is connected to an Altera Avalon interrupt sink BFM for
simulation.
Table 29-21: FPGA-to-HPS Interrupts Interface Simulation Model
f2h_irq0
f2h_irq1
The HPS-to-FPGA peripheral interfaces are connected to Altera conduit BFMs for simulation. When you
enable the peripheral interrupt, the corresponding peripheral signal to the FPGA is exposed.
Table 29-22: HPS-to-FPGA Peripherals Interrupt Interface Simulation Model
Interface Name
h2f_can0_interrupt
h2f_can1_interrupt
Altera Corporation
and
get_*() set_*()
BFM Instance Name
h2f_mpu_events_inst
Interface Name
API functions is the same as with the general Avalon conduit
RTL Simulation API Function
Names
get_h2f_mpu_eventi()
set_h2f_mpu_evento()
set_h2f_mpu_
standbywfe()
set_h2f_mpu_
standbywfi()
f2h_irq0_inst
f2h_irq1_inst
h2f_can0_interrupt_inst
h2f_can1_interrupt_inst
Post‑Fit Simulation API Function Names
get_eventi()
set_evento()
set_standbywfe()
set_standbywfi()
BFM Instance Name
BFM Instance Name
Simulating the HPS Component
cv_5v4
2016.10.28
Send Feedback