Setting Up The Hps Component For Simulation - Altera cyclone V Technical Reference

cv_5v4
2016.10.28

Setting Up the HPS Component for Simulation

The following steps outline how to set up the HPS component for simulation.
1. Add the HPS component from the Qsys Component Library.
2. Configure the component based on your application needs by selecting or deselecting the HPS-FPGA
interfaces.
3. Connect the appropriate HPS interfaces to other components in the system. For example, connect the
FPGA-to-HPS AXI slave interface to an AXI or Avalon-MM master interface in another component in
the system.
When you create your component, make sure the conduit interfaces have the correct role names and
widths. Also make sure the conduit interfaces are opposite in direction to what is shown in the HPS
Conduit Interfaces table.
Related Information
Instantiating the HPS Component
HPS Conduit Interfaces Connecting to the FPGA
The following tables define the HPS Conduit interfaces that connect to the FPGA.
Table 29-1:
h2f_warm_reset_handshake
Role Name
h2f_pending_rst_req_n
f2h_pending_rst_ack_n
Table 29-2: h2f_gp
Role Name
h2f_gp_in
h2f_gp_out
Table 29-3: h2f_mpu_events
Role Name
h2f_mpu_eventi
h2f_mpu_evento
h2f_mpu_standbywfe
h2f_mpu_standbywfi
Simulating the HPS Component
Send Feedback
on page 27-1
Direction
Output
Input
Direction
Input
Output
Direction
Input
Output
Output
Output
Setting Up the HPS Component for Simulation
1
1
32
32
1
1
2
2
29-3
Width
Width
Width
Altera Corporation