Table of Contents
Advertisement
S-127
S-127
General Description
This feature allows the D
call to the desired station/trunk. When the communication with the desired party ends, the announcement
guiding the caller to dial the next desired party number is sent out. The caller, by following the guidance,
can be connected to a number of destinations without hanging up.
Operating Procedure
To operate:
term
1.
The D
user answers the incoming central office line/tie line call.
2.
The caller requests SERIAL CALL, and the D
3.
The caller tells the desired station/trunk number to the D
to the desired station/trunk using Consultation Hold.
4.
When the conversation ends, the caller receives the announcement requesting the caller to dial
the next station/trunk number.
5.
The caller dials the desired station/trunk number. When the called party answers,
communication can begin.
6.
When the conversation ends, the caller receives the announcement requesting the caller to dial
the next station/trunk number. The caller may successively dial the desired station/trunk number.
Service Conditions
1.
Whether to activate this service can be determined on a system basis, but not on a tenant or
incoming route basis. Therefore, it is not available to activate this service for each incoming
route.
2.
Serial Call can be set only for the incoming central office line, tie line, and ISDN line. It cannot
be set for the station or the outgoing trunk.
3.
The station that can set/cancel Serial Call is the D
the incoming call from a ringdown trunk, the call has to be transferred from the Attendant to the
term
D
, or the D
term
4.
The D
may set/cancel Serial Call by pressing the "SERIAL CALL" key any time while
engaged in a call with the incoming trunk party. (The LCD indicates set (SERIAL SET)/cancel
(SERIAL CANCEL) for 5 seconds every attempt and the "SERIAL CALL" key lights red while
Serial Call is set (Note). However, the D
service (i.e. this service cannot be used together with CALL TRANSFER-ALL CALLS-D
11D], CONSULTATION HOLD-ALL CALLS-D
12], etc.).
term
Note:
When the D
service set/cancel indication. The space for 8-digit characters at the right side is blank.
5.
The caller can call the station, central office line, tie line, or the Attendant successively by
activating Serial Call.
6.
When the call terminates on the central office line/tie line in the multi-line and the called station
answers, the "SERIAL CALL" key lights in red. However, in case the D
PICKUP - GROUP [C-7]/CALL PICKUP- DIRECT [C-30], it does not light.
Page 500
Serial Call - D
Serial Call - D
(Series 6100 software feature)
term
user to set SERIAL CALL to the central office line/tie line call and extend the
term
should be previously designated as the Direct-In Termination station.
equipped with 24-digit display LCD, the 16 digits at the left side of the LCD is used for the
term
term
term
user presses the "SERIAL CALL" key.
term
user; the D
term
with the "SERIAL CALL" key. In case of
term
user must not have any other calls when using this
term
[C-17D], CALL WAITING-TERMINATING [C-
NEAX2400 ICS Business Features and Specifications
term
user extends the call
term
term
user answers by CALL
NDA-24143, Issue 4
[C-
Advertisement
Table of Contents
