Table of Contents
Advertisement
M-11
Interactions
1.
MEET-ME PAGING and PAGING ACCESS [P-1] can be provided simultaneously in the same
system. In ARTD, CDN 6:TCL must be assigned as data "8" for MEET-ME PAGE, while PAGING
ACCESS routes may be assigned as data "11", General Page, or as data "1", DDD. Separate
access codes for each feature is required. MEET-ME PAGING answer and cancel codes are
required for each MEET-ME PAGING zone.
2.
MEET-ME PAGING is limited to stations and Attendant Consoles. CO trunks, TIE LINE ACCESS
[T-6] or REMOTE ACCESS TO PBX SYSTEM [R-2] calls must have the Attendant or station user
perform the Paging operation.
3.
The Attendant Console cannot dial the MEET-ME PAGING answer codes.
4.
BUSY VERIFICATION [B-3] and EXECUTIVE OVERRIDE [E-1]: These features will be denied
for a connection, including the Paging route.
5.
DELAY OPERATION: The Attendant Console is connected to party B.
a.) The Attendant dials the MEET-ME PAGE route access code. When connected to the
Page trunk, the Attendant requests Station C to dial the MEET-ME PAGE answer code.
The Attendant presses RLS key. When Station C dials the answer code, Party B is
connected to Station C.
OR
b.) The Attendant presses the HLD key, then seizes an idle loop and dials the MEET-ME
PAGE route access code. After the paging, the Attendant presses the RLS key. When
Station C dials the answer code, Station C terminates to an idle loop key on the
Attendant Console. The Attendant answers and places this call on hold, then
sequentially presses the two held loop keys. This connects the Attendant to the party
connected to the first pressed loop key. The Attendant can either press the TALK key,
creating a THREE-WAY CALLING [T-2] connection, or press the RLS key, allowing
Party B and Station C to be connected.
If Station C does not call the MEET-ME PAGE answer code within 30 seconds, Party B
rings back to the Attendant Console. Normal operating indications are applied.
6.
Stations and Attendant Consoles allowed Priority Page, SFI = 57, will barge into the Paging
route, except when the Attendant Console is paging. An access code to Priority Page must be
assigned in ASPA, SRV = SSC (Service Code), SID 40, and assigned for a Connection Index of
Normal (N).
7.
To answer the MEET-ME PAGE while connected to another party, CALL HOLD [C-6] must be
used. THREE-WAY CALLING [T-2] is not allowed.
Page 316
Meet-Me Paging - Attendant
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Advertisement
Table of Contents
