Table of Contents
Advertisement
D-7
D-7
General Description
This feature automatically routes incoming public network calls directly to a pre-selected station without
Attendant assistance. The call can then be processed by the called party. THREE-WAY CALLING [T-2],
CALL TRANSFER [C-10], etc., are handled in the same manner as any normal trunk call.
Operating Procedure
The calling party, outside the system, dials the telephone number as usual. However, the call is answered
directly at a predetermined station, bypassing the ATTENDANT CONSOLE [A-3].
Service Conditions
1.
Any group(s) of trunks can be used, up to the maximum capacity of the NEAX2400 ICS.
2.
Bothway trunks can be used for DIRECT-IN TERMINATION, but incoming only trunks are
recommended.
3.
It is not necessary to have special DID trunk connections to the public network as is required with
DIRECT INWARD DIALING [D-8]. However, care should be exercised in the application of
Central Office trunk hunting.
4.
If the DIT station is busy, the incoming call is kept ringing until the DIT station becomes idle, or
forwarded to the ATTENDANT CONSOLE [A-3].
5.
If there is no answer at a station, the calling party will continuously receive Ringback Tone. There
is no AUTOMATIC RECALL [A-8] to the Attendant in this case.
6.
If the station is assigned to a STATION HUNTING [S-7, 8, 9] group, the incoming call will follow
the hunt group station assignment. If the station is in a CALL FORWARDING [C-2, 3, 5] mode,
the incoming call is connected to the CALL FORWARD target station.
7.
This feature is normally used where direct-in service is required on a limited basis. The number
of stations serviced is effectively limited to the number of trunks available for DIRECT-IN
TERMINATION.
8.
DIRECT-IN TERMINATION is mutually exclusive with NIGHT CONNECTION - FIXED [N-1].
9.
DIT trunks can be programmed to terminate elsewhere in the Night mode.
10. When the system is in the Night mode of operation and the DIRECT-IN TERMINATION (DIT)
station is busy, the call will divert to TAS if provided, otherwise, the call will wait on the busy
station until it becomes idle.
11. More than one trunk can be arranged for DIRECT-IN TERMINATION to a particular station line.
12. The DIT call can terminate to a DO NOT DISTURB [D-11D] station.
13. When a DIT call terminates to a restricted station or a station setting CALL FORWARDING - ALL
CALLS [C-5]/BUSY LINE [C-2], or MULTIPLE CALL FORWARDING - ALL CALLS [M-44] /
BUSY LINE [M-24] to a restricted station, the call is routed to the Attendant and terminates at the
"ICPT" key on the ATTENDANT CONSOLE [A-3].
Note:
This service can be activated in System Data.
14. After a call is answered, it can be processed by the called station like any normal trunk call.
Page 198
Direct-In Termination (DIT)
Direct-In Termination (DIT)
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Advertisement
Table of Contents
