Table of Contents
Advertisement
Interactions (cont'd)
3.
NIGHT CONNECTION-FIXED/FLEXIBLE [N-1, 2]: TAS can be used in conjunction with NIGHT
CONNECTION-FIXED/FLEXIBLE [N-1, 2]. When the Night Connection station(s) is busy,
incoming calls are directed to TAS.
4.
CALL TRANSFER-ALL CALLS [C-11]: A station answering a call via the TAS feature will have
access to the transfer feature.
5.
CENTRALIZED ATTENDANT SERVICE (CAS) [C-20]: TAS may be installed at either the Main
site only or at both the Main and Satellite sites. Operations at either site are the same as TAS
installed in a non-CAS system. The Satellite system must have a means of placing the system
into Night mode. This would require an ATI circuit card connected to a Night switch.
6.
CALL FORWARDING - ALL CALLS [C-5] / BUSY LINE [C-2]: When a Direct Inward Dialing (DID)
call terminates to a station setting CALL FORWARDING - ALL CALLS [C-5] or BUSY LINE [C-
2] to the Attendant, the call can be answered using the TAS feature.
7.
CLASS OF SERVICE-INDIVIDUAL [C-15]: Stations must be allowed access to TAS via Service
Feature Class. The station Route Restriction Class will either allow or deny connection to
incoming C.O. calls via TAS.
8.
DAY/NIGHT CLASS OF SERVICE [D-15]: A CLASS OF SERVICE-INDIVIDUAL [C-15] change
that occurs when the system goes into Night mode may allow a station to answer incoming trunk
calls that are restricted to that station in Day mode.
9.
HOUSE PHONE [H-2], INDIVIDUAL ATTENDANT ACCESS [I-6], STATION-TO-STATION
CALLING-OPERATOR ASSISTANCE [S-12], and ATTENDANT NIGHT TRANSFER [A-19]:
These calls will not be directed to TAS when the system is in Night mode.
10. CONSULTATION HOLD [C-17]: TAS cannot be accessed via CONSULTATION HOLD.
11. TRUNK ANSWER ANY STATION will not default if other provisions are not made to answer
incoming calls when the system is in Night mode. See the ACFR command.
12. The type of Attendant Console system used determines how the system will enter into the Night
mode. See System Data 2, Index 2, Bits 2 & 3.
13. A station user receives a Reorder Tone after dialing the TAS access code if one or more of the
following applies:
a.) Station line is inward restricted.
b.) Station line is fully restricted.
c.) Station is restricted from the TAS access code.
d.) Station has a party on Hold.
e.) Another station has answered the TAS call and no other calls are in the TAS queue.
14. Incoming calls remain in the TAS queue until answered from a station or until abandoned by the
far end.
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Trunk Answer from Any Station (TAS)
T-8
Page 517
Advertisement
Table of Contents
