Table of Contents
Advertisement
L-21
General Description
This feature allows the MAT [M-18] to deny a preselected group of stations the ability to originate calls by
activating a command key. The sole intention of this feature is to temporarily restrict the least important
internal stations from outward calling during an excessive traffic load or emergency conditions.
Operating Procedure
The ALLC command is used to designate start and stop of LINE LOAD CONTROL - MAT. Refer to
NEAX2400 ICS Command Manual.
Service Conditions
1.
Individual stations are programmed for this feature via CLASS OF SERVICE - INDIVIDUAL [C-
15].
2.
The lamp on the ATTENDANT CONSOLE [A-3] will illuminate when LINE LOAD CONTROL -
MAT is set in the system.
3.
Incoming calls from a trunk can be restricted in System Data.
4.
When LINE LOAD CONTROL - MAT is activated, a station will receive Busy Tone (or the display
term
for the D
5.
A station in LINE LOAD CONTROL [L-11, 20, 21] can receive incoming calls.
6.
When LINE LOAD CONTROL - MAT is activated or cancelled, a system message will be output
on the MAT [M-18].
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Line Load Control - MAT
Line Load Control - MAT
is blank) when going off-hook.
L-21
Page 301
Advertisement
Table of Contents
