Table of Contents
Advertisement
C-62
Consecutive Speed Calling - System
General Description
This feature allows a station user to call frequently dialed DID numbers using fewer digits (abbreviated
call codes) than would normally be required. The stored digits would include route access code, area code
and office code. The caller would then manually enter the called station number.
Operating Procedure
To operate:
1.
Dial the Speed Calling access code (1 or 2 digits).
2.
Dial the abbreviated call code (2 or 3 digits).
3.
Dial 4 digit station number. The call is completed.
Service Conditions
1.
SPEED CALLING codes programmed in System Data are accessible to all stations with a
CLASS OF SERVICE - INDIVIDUAL [C-15] that allows CONSECUTIVE SPEED CALLING-
SYSTEM.
2.
Each abbreviated call code can consist of a maximum of 24 digits, including access codes.
3.
The maximum numbers of CONSECUTIVE SPEED CALLING - SYSTEM codes that can be
stored in the system is 1000 in IMG (ICS), IMGx, IMGxh, IMGdxh, MMG/UMG (ICS), and UMGx.
Note:
The capacity depends on the system configuration due to memory requirements.
4.
Speed Calling numbers are programmed via System Data entry on the MAINTENANCE
ADMINISTRATION TERMINAL (MAT) [M-18].
5.
Stations may be denied access to Speed Calling via CLASS OF SERVICE - INDIVIDUAL
assignment in System Data. Speed Calling may also be allowed or denied on a system or tenant
basis.
6.
TOLL DENIAL/TOLL DIVERSION [T-6] and TOLL RESTRICTION - 3/6-DIGIT [T-7] may be
applied to Speed Calling, if desired.
7.
LEAST COST ROUTING - 3/6-DIGIT [L-5] may be provided for Speed Calling access.
8.
This feature cannot be used for an outgoing call that uses OUTGOING TRUNK QUEUING [O-2].
9.
CONSECUTIVE SPEED CALLING-SYSTEM may not be accessed via CONSULTATION
HOLD.
10. Digits dialed after the abbreviated call codes are not recorded on SMDR.
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Consecutive Speed Calling - System
C-62
Page 171
Advertisement
Table of Contents
