Table of Contents
Advertisement
S-99
Operating Procedure (cont'd)
a.) Press an idle loop key and dial the FWD, FWD-BY, or FWD-DA access code for an
incoming call from an outside party; receive Special Dial Tone.
b.) Dial the Tenant Number (2 digits) of the originating station and the originating station
number; receive Service Set Tone.
c.) Press the RLS key.
Service Conditions
1.
The same station can be set as the transfer target station for an incoming call from an outside
party and/or from a station.
2.
For an incoming call from a trunk, whether Call Forwarding destination for an incoming call from
a station or for an incoming call from an outside party is to be used can be designated on each
incoming route basis. (According to ARTD command, CDN 68:SCF, data.)
3.
When an incoming call from a trunk is handled via the Attendant/station, the destination of Call
Forwarding is selected according to the route data of the incoming trunk (as assigned by ARTD
command, CDN 68:SCF).
4.
This service is invalid on Call Forwarding by the system. (Call Forwarding by the ACFO
command.)
5.
Multiple Call Forwarding is available for those stations where SPLIT CALL FORWARDING has
been set.
6.
This service can be set from the Attendant Console.
Station A
Station B
Station C
Ex. In a case where station A has set Station B as the transfer target station for an incoming call from a station,
and has set Station C as the transfer target station from an incoming call from an outside party.
•
When a call from a station terminates to Station A, the call is transferred to Station B.
•
When a call from TRK A terminates to Station A, the call is transferred to Station C.
•
When a call from TRK B terminates to Station A, the call is transferred to Station B.
7.
Indication of SPLIT CALL FORWARDING (ALL CALLS/BUSY LINE/DON'T ANSWER) feature
can be accomplished only if the Service Feature Restriction Class and access codes are
assigned properly.
8.
This feature is available for stations where CALL FORWARDING services are available by
CLASS OF SERVICE.
9.
Multiple Call Forwarding is available for those stations where SPLIT CALL FORWARDING has
been set.
10. In the UCD procedure, if SPLIT CALL FORWARDING - ALL CALLS (either for station-to-station
or incoming trunk) is set on a station in the group, that station is skipped.
Page 496
Split Call Forwarding
Trunk route assigned to ARTD, SCF = 1
TRK A
TRK B
Trunk route assigned to ARTD, SCF = 0
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Advertisement
Table of Contents
