Table of Contents
Advertisement
N-28
Operating Procedure (cont'd)
3.
When both the calling/called station are released from a station-to-station call, the LCD of the
calling/called station displays:
term
D
Series E
Service Conditions
1.
This service is available when either of the calling/called station is a D
2.
Characters of 8-Bit JIS code data can be displayed.
3.
User information corresponding to the station number that can be displayed on the LCD is a
maximum of 16 digits. The information displayed may consist of upper case letters, numeric
characters, and most keyboard symbols.
4.
This service and Name Display service by Open Application Interface (OAI) cannot be activated
concurrently.
5.
8-digit display or 16-digit display is selectable by System Data, but cannot be used concurrently.
6.
16-digit display:
a.) 16-digit display is available only in case of station (MY Line only) -to-station (MY Line
only) calls between D
b.) User information is displayed on the lower line of LCD, indented to the left. When the
information is less than 16 digits, the unused digits are left blank. The information cannot
be displayed on the upper line of LCD.
7.
8-digit display:
a.) User information is displayed on the upper line of LCD, on the right side from the center.
When the information is less than 8 digits, the unused digits are left blank.
b.) 8-digit display of user information is also available for D
8.
If the station has no name programmed for Name Display service, the station number is repeated
in the name field.
9.
User information will not be guaranteed when 16-digit display service is changed to 8-digit
display service.
10. When station number has been changed to a new one, the station number and user information
to be displayed cannot be guaranteed. Therefore, System Data assignment must be properly
managed.
11. User information may be assigned to all sub-lines of a D
12. (Series 6100 software enhancement) For the SIM (ICS), IMGx, IMGxh, IMGdxh, and MMG/
UMG (ICS) and UMGx, the Name Display data stored on the hard disk is loaded to the memory
at the time of system initialization (including power on) or when the office data load initialization
is requested by MAT command or the keys on the TOPU.
13. (Series 6100 software enhancement) The Name Display data is backed up to the hard disk at
the time of routine diagnosis.
Page 382
Name Display - System
(Time Display)
(Time Display)
term
s with 2-line LCD display.
term
, with an LCD display.
term
with 1-line LCD display.
term
.
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Advertisement
Table of Contents
