Table of Contents
Advertisement
Service Conditions (cont'd)
Note:
Capacity varies depending on system configuration. It is possible to attain limits of:
IMG, IMGx:
IMGxh, IMGdxh, MMG, UMG:
These specifications are based on the digits being assigned as follows:
1st digit:
2nd digit:
3rd digit:
4th digit:
5th - 8th digits:
9th & 10th digits:
Note:
See ETI: 082 for details on AUTHORIZATION CODE/FORCED ACCOUNT CODE [F-7] assignment.
9.
Service Set Tone is common to AUTHORIZATION CODE, ACCOUNT CODE [A-18] and
FORCED ACCOUNT CODE [F-7], but can be eliminated by System Data as required.
10. AUTHORIZATION CODE and FORCED ACCOUNT CODE [F-7] cannot be provided
simultaneously for the same tenant group. System Data determines, on a per-tenant basis,
whether AUTHORIZATION CODE or FORCED ACCOUNT CODE [F-7] is used.
11. AUTHORIZATION CODE dialing (Procedure 1) is also effective with CONSULTATION HOLD
[C-17]. Special Dial Tone is received instead of Dial Tone after AUTHORIZATION CODE.
12. Procedure 2 is effective only for LEAST-COST ROUTING - 3/6-DIGIT [L-5] calls.
13. Stations must be assigned for Procedure 1 and 2 via CLASS OF SERVICE - INDIVIDUAL [C-5]
programming in System Data.
14. In Procedure 1, System Data can determine, on a per-tenant basis, whether or not an ACCOUNT
CODE [A-18] follows the AUTHORIZATION CODE.
15. Assigned AUTHORIZATION CODES can be used for the REMOTE ACCESS TO SYSTEM
[R-2] function.
16. OG TRUNK QUEUING [O-2] and OFF-HOOK QUEUING [O-7] can be set according to the
Service Feature Class of the user's AUTHORIZATION CODE.
17. AUTHORIZATION CODE can be recorded in the STATION MESSAGE DETAIL RECORDING
[S-10] for Procedure 2.
18. The registered/non-registered condition of the AUTHORIZATION CODE is not included in the
information block of Condition B on the SMDR output format.
19. Attendant cannot activate this feature by Procedure 1.
20. See service conditions for the AUTHORIZATION CODE DISPLAY ELIMINATION [A-99].
Interactions
1.
If FORCED ACCOUNT CODES [F-7] are used, AUTHORIZATION CODES are not used within
the same tenant.
2.
AUTHORIZATION CODES may be used in conjunction with ACCOUNT CODES [A-18].
3.
When assigning an AUTHORIZATION CODE Restriction of 1 in AATC, the RSC must be
constructed in ARSC.
4.
AUTHORIZATION CODES can be unrestricted or assigned one of 15 Route Restriction Classes
(RSC) - 15.
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Authorization Code
approx. 4,000 codes
approx. 20,000 codes
A (when A equals a unique digit from 0 - 9)
B - C (when b, c equal any two unique digits from 0 - 9)
D-E (when d, e equal any two unique digits from 0 - 9)
F-G-H (when f, g, h equal any three unique digits from 0 - 9)
Any combination 0 - 9
Assigned using the checksum. These are for validation purposes only. See
ETI: 091 for more details.
A-20
Page 27
Advertisement
Table of Contents
