Table of Contents
Advertisement
S-26D
S-26D
General Description
This feature allows 24-button D
24 numbers may be programmed by the D
Operating Procedure
To program:
1.
Press the FNC key.
2.
Press the SPEED CALLING-ONE TOUCH button.
3.
Dial the desired number.
4.
Press the FNC key again.
5.
Display will show SPD SET.
Note:
The page-change function works as follows: If the Page button is unlit, Page 0 Speed Dial memory is being
programmed. (This is the same memory that would be used if the Page feature were not being used.) Then,
to program Page 1, press FNC, the SPEED CALLING-ONE TOUCH button, the desired number, and the
FNC key again. Use of the Page feature allows twice the number of equipped spd keys to be used.
To verify:
Press the FNC button and the desired SPEED CALLING-ONE TOUCH button: The first 16 characters will
be displayed.
To use:
Press the SPEED CALLING-ONE TOUCH button, the call will complete.
Service Conditions
1.
Up to 12 numbers may be stored per D
2.
Up to 24 numbers may be stored per D
on Page 1.
3.
A stored number may have up to 32 digits, including access codes and pauses.
4.
Only the first 16 digits are displayed on the LCD.
5.
SPEED CALLING-ONE TOUCH numbers may only be stored while the D
6.
Storing a SPEED CALLING-ONE TOUCH number erases the previously stored number.
7.
After dialing the new number, the user must press the SPEED CALLING-ONE TOUCH key
before the LCD displays the time. If the LCD displays the time before the user presses the key,
the number has not been stored. The LCD displays SPD SET when the number has been stored.
8.
Pressing the RCL key while programming a SPEED CALLING-ONE TOUCH number inserts a
pause. A dash ("-") is displayed on the LCD.
9.
Pressing the RCL key as the first digit of a SPEED CALLING-ONE TOUCH numbers inserts a
flash entry. A "!" is displayed on the LCD.
10. If a VOICE CALL-D
programmed onto a SPEED CALLING-ONE TOUCH key. The user dials the number and then
presses the XFR key when programming SPEED CALLING. The LCD will display V after the
number. Pressing the SPEED CALLING-ONE TOUCH key initiates an automatic Voice Call to
the programmed station.
Page 480
Speed Calling - One Touch - D
Speed Calling - One Touch - D
term
users to dial telephone numbers by pressing a single key. Up to 12/
term
term
(V-2D) feature is programmed, VOICE CALL initiation can be
term
station users.
term
.
term
, 12 numbers on Page 0 and 12 additional numbers
NEAX2400 ICS Business Features and Specifications
term
term
is idle.
NDA-24143, Issue 4
Advertisement
Table of Contents
