Table of Contents
Advertisement
P-10
P-10
General Description
This feature will allow a station user to transfer a paged call to a party that has been placed on hold.
Operating Procedure
While a station user is engaged in a call:
1.
Switchhook flash; receive Special Dial Tone.
2.
Dial the Paging Access Code; receive continuous Ringback Tone for approximately one second.
3.
Page the desired party.
There are three paging options:
1.
NON-DELAY SYSTEM: The party paged is immediately connected to the paging station when
the paged party dials the Paging Answer Access Code.
2.
DELAY SYSTEM: The paging station user replaces the handset after the page; the paged party
dials the Paging Answer access code. The paging station rings, and the paged station receives
Ringback Tone. After the paging station user lifts the handset, the paging and paged stations are
connected.
3.
PAGING TRANSFER SUPERVISION: The paging station user replaces the handset after the
page. By dialing the Paging Answer access code, the paged party is directly connected to the
party on hold.
For Non-Delay and Delay systems: When a paging station replaces the handset after talking with the
paged party, the held party is directly connected to the paged party.
Service Conditions
1.
PAGING TRANSFER service can be selected according to System Data assignment:
a.) Non-Delay system
b.) Delay and Non-Delay system
c.) PAGING TRANSFER Supervision
2.
Paging trunks can be provided for a maximum of six routes.
3.
When a paging route has been accessed and is not answered within a predetermined time, the
paging activation is automatically cleared.
4.
Both the COT card and the TLT card can be used as the paging trunk.
5.
Loop signaling is the recommended signaling type.
Interactions
1.
PAGING TRANSFER (MEET-ME PAGING) and PAGING ACCESS [P-1] can be provided
simultaneously in the same system. Separate access codes for each service is required. A
MEET-ME PAGING answer code is required for each MEET-ME PAGING zone.
2.
Paging is limited to stations and Attendant Consoles. Other parties (CO and TIE trunk calls) must
have the Attendant Console or station user perform the paging operation.
3.
The Attendant cannot dial the MEET-ME PAGING answer codes.
4.
BUSY VERIFICATION [B-3], EXECUTIVE OVERRIDE [E-1]: These features will be denied to
Paging routes assigned in CDN 6:TCL as data "8", Page with Ringback Tone.
Page 412
Paging Transfer
Paging Transfer
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Advertisement
Table of Contents
