Table of Contents
Advertisement
A-53
General Description
This feature provides both the Attendant and a station user with dial access to multiple zone paging
equipment.
Operating Procedure
To operate from a station:
1.
The station goes off-hook; receives Dial Tone.
2.
The station dials the ALL-ZONE PAGING access code.
3.
Connections to multiple paging equipment are established.
Service Conditions
1.
This feature allows only Paging access. PAGING TRANSFER [P-10] and MEET-ME PAGING
[M-11] are not provided.
2.
A maximum of seven Paging Zones can be accessed simultaneously.
3.
When a station user or an ATTENDANT CONSOLE [A-3] has a held station or trunk, this feature
is not activated.
4.
If the Paging trunk is busy, the Paging connection is not established to the busy zone.
"PRIORITY PAGING [P-30] access code" + "ALL-ZONE PAGING [A-53] access code" dialing is
possible. Even if this dialing operation is performed, the PRIORITY PAGING [P-30] function is
not activated when the line is busy; i.e., it has the same result as ALL-ZONE PAGING access
code dialing.
5.
One trunk circuit is required for each PAGING ACCESS [P-1].
6.
Amplifiers and speakers must be customer provided.
7.
Where TENANT SERVICE [T-12] is provided, separate access codes and hardware should be
provided for each tenant.
8.
The ALL-ZONE PAGING access code is three digits maximum. (Outgoing Call Alternative
(OGCA))
9.
Both the COT card and the TLT card can be used as the paging trunk.
10. Loop signaling is the recommended signaling type.
Interactions
1.
MEET-ME PAGING [M-1, 11] and ALL-ZONE PAGING [A-53] can be provided simultaneously
in the same system.
2.
To directly answer ALL-ZONE PAGING by the Attendant Console, the Paged party should use
the INDIVIDUAL TRUNK ACCESS [I-4] feature.
3.
Paging is limited to stations, Attendant Consoles, or TIE Trunks. Other parties (CO trunk calls)
must have the Attendant Console or station user perform the Paging operation.
4.
BUSY VERIFICATION [B-3], EXECUTIVE RIGHT-OF-WAY [E-1]: These features will be denied
if the Paging route has been assigned for Privacy. Verify the data in the Assignment of Route
Data command, ARTD, CDN 44:PRV. If TCL is assigned as Data 8, CDN 44:PRV is not required.
5.
For simple ALL-ZONE PAGING, assignments in ASFC are not required. Refer directly to the
other Paging service features, such as PAGING TRANSFER [P-10].
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
All Zone Paging
All Zone Paging
A-53
Page 37
Advertisement
Table of Contents
