Cycle Alarms - Siemens SINUMERIK 808D ADVANCED Diagnostic Manual
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages) ,
- Operating instructions manual (498 pages)
Table of Contents
Advertisement
5.3
Cycle alarms
To view detailed description about individual alarms directly on the PPU, proceed as follows:
61000
%[[Channel %1: ] Block %2: %]No tool offset active
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
D-correction must be programmed before the cycle call.
Programm
Clear alarm with the RESET key. Restart part program
continuation:
61001
[Channel %1: ] Block %2: Thread pitch incorrectly defined
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Check parameter for the thread size or setting for the pitch (contradict each other).
Programm
Clear alarm with the RESET key. Restart part program
continuation:
61002
%[[Channel %1: ] Block %2: %]Type of machining incorrectly defined
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
Remedy:
Modify VARI parameter.
Programm
Clear alarm with the RESET key. Restart part program
continuation:
61003
%[[Channel %1: ] Block %2: %]No feed programmed in cycle
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
1.
Press this key on the PPU to enter the alarm operating area.
2.
Select the desired alarm.
3.
Press this key to open the online help for the selected alarm.
SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
363
Hide quick links:
Advertisement
Table of Contents
