Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 458

SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Load a milling tool, before you call positioning.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61552 [Channel %1: ] Block %2: Alignment of milling tool not possible with active grinding tool
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: Alignment of milling tools is not possible with an active grinding tool.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Load a milling tool before you call alignment.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61553 [Channel %1: ] Block %2: Alignment of grinding tool only possible with active grinding tool
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: Alignment of grinding tools is only possible with an active grinding tool.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Load a grinding tool before calling alignment.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61555 [Channel %1: ] Block %2: Diameter of grinding wheel ==0, GWPS cannot be calculated
Parameters: %1 = Channel number
%2 = Block number, label channel number
Explanation:
Remedy: Check diameter
Programm Clear alarm with the RESET key. Restart part program
continuation:
61556 [Channel %1: ] Block %2: Impossible chamfer and radius of left edge of wheel
Parameters: %1 = Channel number
%2 = Block number, label channel number
Explanation:
Remedy: Check values in grinding wheel data
Programm Clear alarm with the RESET key. Restart part program
continuation:
458
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
Diagnostics Manual