7.6
Alarms
7.6.1
Set the common parameters
①
②
④
⑤
⑥
⑦
Prerequisite: You must know the details of your application and substitute the values for the
sample values provided. If you are bench testing the device, then set your test values to be
the same as the sample values.
Parameter
Sensor Mode (2.1.2.) (Page 173)
or
Sensor Mode (2.1.3.) (Page 173)
Response Rate in Quick Start (Page 59)
Transducer (2.1.6.) (Page 174)
Units (2.1.1.) (Page 172)
Flowrate Units (2.15.3.7.) (Page 238)
Low Calibration Point (2.2.1.) (Page 176)
High Calibration Point (2.2.2.) (Page 176)
Note
When configuring alarms, more than one alarm can be assigned to the same relay.
SITRANS LUT400
Operating Instructions, 04/2021, A5E33329501-AG
Low level value
Material level reading
High level value
Level
Sensor reference point
High calibration point
Description
LEVEL
FLOW
MEDIUM
XPS-10
M
L/S
1.8
0.4
General Operation
7.6 Alarms
99